Pumps and Motors

Pages

Hello,

I have a borewell which is 412ft deep having a 8" dia. We were using a 12 stage, 5 HP pump, 2" HDPE pipe and best quality power cable and were able to get good water. A few days ago I installed a 7.5 hp pump which was recommended by most of the people to maximise use but after 30 minutes of pumping, the motor was jammed with mud. When I checked the bore, I found that it was now only 290 ft deep which means that 112 ft was filled with yellow mud.

I would like to know as to how I can resolve this problem and retain the borewell. 

Topics

Sub-Categories

Regions

Hello,

I have a borewell which is 430ft deep. My motor and pipes are stuck in the borewell at 200ft. I need contacts of people who can help me remove this in Prakasham District in Andhra Pradesh. Please help. My contact number is 8142389085

Topics

Sub-Categories

Regions

Hello

Our borewell is 840 ft deep but we got water at 780 ft. We have installed Texmo submersible motor. It runs for few seconds and the meter reads at 12-15 amps but there is no water. I get the message on display 'dry'. Someone was saying that I should have got some water at least after monsoon re-charge as I did get water in the first 6 months of digging the borewell.

Please suggest what needs to be done. Is it the problem with the borewell or with the motor?

 

Topics

Sub-Categories

Regions

 Hello,

My borewell is 600 feet deep, with 20 feet casing. It has 6" dia. I want to use this for agricultural purposes. Can anyone guide me as to how I should calculate the required capacity (hp) of the submersible pump for this borewell? What are the factors to be considered?

 

Topics

Sub-Categories

Regions

Hello,

Topics

Sub-Categories

Regions

Hi,

We have a borewell with a motor at 500ft depth. During rainy season, there was a little seepage of muddy water and the motor stopped functioning. When we checked with a borewell person he told that borewell motor is stuck with mud and cannot be pulled out. So we had a pipe blasting and pulled out the remaining pipe and thread. WE were told that after this we annot use the motor. We scanned the borewell using a camera and fund that there is another source at 180 ft and can use that by installing a new motor. Please help me with the following points.

Topics

Sub-Categories

Regions

Hello,

My submersible pump is stuck in the borewell at 190 feet. I am not able to remove it. Roots of trees may have entangled at 40 feet depth. Kindly suggest how I can remove the pump.

Topics

Sub-Categories

Regions

Hello,

We are using a  2.5 hp air compressor for water supply from a borewell of 270 ft depth, since the water table is not sufficient enough for using a submergible pump. Can you please tell us which grade of oil is to be used for such compressors as lubricant?  Since it is a local make we have not been given any booklet of specifications, etc. Please suggest.

Topics

Sub-Categories

Regions

Hi,

We had got a borewell dug in 2010 which was giving good water since then. Few weeks ago we got little muddy water. Now when we are switching on motor the MCB reading is 15 amps (used to get water at 15amps, 200v earlier) with no water. After a while it drops to 13 amp again with no water. The voltage is steady at 200v. What can be the possible reason for this? Please help 

Thanks,

 

Topics

Sub-Categories

Regions

Hello,

i need suggestion to install submersible pump for a 300ft deep borewell used for domestic purpose. Kindly let me know the capacity of the pump that needs to be installed.

Topics

Sub-Categories

Regions

Pages

Subscribe to RSS - Pumps and Motors