Pumps and Motors

Pages

Hello,

Our borewell is 380 feet deep. We have purchased a 5HP pump with a head of 75 meter and discharge of 210 lpm. Please suggest if this is sufficient?

Topics

Sub-Categories

Regions

Hello,

If we suck the groundwater from borewell, what happen to the empty space? Does it get filled with air? If the pump is placed inside the borewell, is the water sucked from water level above the pump or the water level below the pump.

Topics

Sub-Categories

Regions

Hello,
I have a borewell which is about 300 ft deep. I would like to know whether a submersible motor or compressor motor, which is preferable for household purpose.

Topics

Sub-Categories

Regions

Hello,

I have a 4 Inch borewell with water at 60 ft. The total land area is 1 hectare for irrigation. I will be requiring a maximum of 40000 ltr per hour water as I am going to install drip irrigation system in my farm. Can you suggest an appropriate submersible pump which can work for me efficiently and consume less energy?

Regards.
Manish.

Topics

Sub-Categories

Regions

Hi,

I have recently dug a bore well and have got water on 675 feet. I need assistance in deciding the capacity of the motor I need to use. Some suggestions have been that I should use a 3HP, 40 Stages, 3-Phase motor. Is this correct? Kindly suggest.

Topics

Sub-Categories

Regions

Hi,

I have constructed 75000 L underground RCC water tank. The tank depth is 12 feet. I want to install a mono-block pump inside the house. The distance of the pump from the water tank is 100 Feet. I want to fill up an overhead tank of 1000L capacity which is located at a height of 30 feet. Need to know if a mono-block pump can have suction of 100 feet length. What capacity (HP)  pump will I require to pump water from the underground tank to fill the overhead tank. Please guide me.

Topics

Sub-Categories

Regions

Hello,

I have a borewell which is 412ft deep having a 8" dia. We were using a 12 stage, 5 HP pump, 2" HDPE pipe and best quality power cable and were able to get good water. A few days ago I installed a 7.5 hp pump which was recommended by most of the people to maximise use but after 30 minutes of pumping, the motor was jammed with mud. When I checked the bore, I found that it was now only 290 ft deep which means that 112 ft was filled with yellow mud.

I would like to know as to how I can resolve this problem and retain the borewell. 

Topics

Sub-Categories

Regions

Hello,

I have a borewell which is 430ft deep. My motor and pipes are stuck in the borewell at 200ft. I need contacts of people who can help me remove this in Prakasham District in Andhra Pradesh. Please help. My contact number is 8142389085

Topics

Sub-Categories

Regions

Hello

Our borewell is 840 ft deep but we got water at 780 ft. We have installed Texmo submersible motor. It runs for few seconds and the meter reads at 12-15 amps but there is no water. I get the message on display 'dry'. Someone was saying that I should have got some water at least after monsoon re-charge as I did get water in the first 6 months of digging the borewell.

Please suggest what needs to be done. Is it the problem with the borewell or with the motor?

 

Topics

Sub-Categories

Regions

 Hello,

My borewell is 600 feet deep, with 20 feet casing. It has 6" dia. I want to use this for agricultural purposes. Can anyone guide me as to how I should calculate the required capacity (hp) of the submersible pump for this borewell? What are the factors to be considered?

 

Topics

Sub-Categories

Regions

Pages

Subscribe to RSS - Pumps and Motors