Pumps and Motors

Pages

Hello,

Could you please suggest me the best brand of submersible pump for domestic use.

Thanks,
Manish

Topics

Sub-Categories

Regions

Our borewell is 840 ft deep with the first water source at 480 ft depth and second at 830 ft 2 inch depth. While scanning we found mud filled at 810 feet onwards and water level stored till 630 ft.

Please suggest ways to clean the mud ? How much will the cleaning cost? Will cleaning the borewell be useful? After cleaning, which capacity motor and at what depth, should be installed to pump water?

Topics

Sub-Categories

Regions

Hi,

Topics

Sub-Categories

Regions

Hello,

I have dug a borewell 320feet deep. Slating pipe, 4 gauge was inserted. 4 months later we tried inserting a 2hp motor at 220 feet  which got stuck due to sand filling in the bore. We somehow removed the motor and tried inserting it back. But it has now gor stuck at 140 feet depth and cannot be removed as the slated pipe is broken at some point. What is the solution to resolve this issue? What are the steps to be taken?

Topics

Sub-Categories

Regions

Hi

Recently the submersible pump I was using in the borewell stopped working. I was not able to remove the pump due to boulders. So the pump was detached and left in the borewell. The total depth of the borewell is 500 feet with water source at 470 feet. The diameter of the borewell is almost 6 inches with casing till 200 feet.  Boulders are seen at 330 feet and current water level is 270 feet. The water source seems good as 1 inch yield has been reported. Yesterday I used a temporary submersible pump and was able to pump water for continous 45 minutes without any issues.

Topics

Sub-Categories

Regions

Hello,

I have a borewell in Kuppam area in Andra Pradesh which is 650 feet deep and 6.5 inches wide. Currently I have a 7.5 HP pump installed at 360 feet. I get 1 to 1.5 inches water continuously even if the motor runs for 6 hours. Is there a way to increase the water discharge? Even though there was no rain as expected the water discharge was the same throughout 2013 till now. Now how can I increase the discharge so that I have enough water to start more cultivation in my land. Please advise

Thanks & regards

Uday

Topics

Sub-Categories

Regions

My bore well is 600 feet deep and the water level is below 400 feet. We have single phase power supply. Can a submersible pump draw water with single phase power? If so please suggest what capacity and which make pump would be suitable.

Regards,

Kishore
wjacobkishore@gmail.com

Topics

Sub-Categories

Regions

Need costing details of 10 Hp submersible pump

Topics

Sub-Categories

Regions

Hi,

We would like to know the capacity of the motor that is to be used to pump 2 inch water from 850 feet depth and supply it through a 3 inch dia, 2 km long pipeline.

Can somebody please guide me.

Thanks in advance.

Topics

Sub-Categories

Regions

Hello,

Topics

Sub-Categories

Regions

Pages

Subscribe to RSS - Pumps and Motors